Skyline Turbo Upgrades
SKYLINE RB26DETT

Ball Bearing Turbocharger Upgrade

Cheetah RB26DETT Bolt-On Upgrade

Warning - Please Read!

After fitting a higher flowing turbocharger it is crucial the vehicle be dyno-tuned by a mechanic who is experienced with tuning turbocharged vehicles BEFORE putting your foot into it no matter how tempted you are to give it a quick squirt!

Air fuel ratio, timing, fuel flow, fuel pressure, inlet manifold vs exhaust manifold pressures etc., all need to be checked. The mechanic should set the boost at a safe level & determine what if any modifications are required to further increase boost!

Failure to have your vehicle dyno-tuned after major component modifications will insure an engine & consequential turbocharger failure!!!


Note


You cannot fit different type turbochargers on a twin-turbo application as configured on a RB26DETT, therefore you would need to purchase a matching pair!

 

 

ACCELERATION!  MUSCLE!  STEALTH!

Rated 300+ HP Per Turbo

Features
    • Dual Ball Bearing
    • Oil & Water Cooled
    • 2 Bolt Compressor Inlet
    • 2 Bolt Compressor Outlet
    • Internally Wastegated
    • GT28 Turbine Inlet Flange*
    • *Threaded Bolt Holes
    • 5 Bolt Turbine Outlet Flange
  • Inconel Turbine Wheel*
  • Ni-Resist Turbine Housing*

*Cast with additional Nickel For Extreme Applications! This Allows for Increased Turbo Reliability under Higher Sustained Boost & Temperature Conditions such as Race or Rally.


Compressor   Turbine
Inducer Ø:
Exducer Ø:
Trim:
A/R:
44.5mm
60.0mm
55
0.42
 


Wheel Ø:
Trim:
A/R:
Wastegated

53.9mm
62
0.64
Internal

Nissan Skyline GTR Turbocharger
  • OEM Replacement For R34 N1
  • Upgrade For RB26DETT R32/R33/R34 GTR

GARRETT P/N: 707160-0007

 


P/N: GT2860-GTR-7
 


Free Delivery Australia Wide
 
Go to top